Tractor Talk Discussion Board |
Re: wisconsin AENL
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on October 06, 2002 at 18:13:11 from (12.148.160.138):
In Reply to: wisconsin AENL posted by Dons on October 06, 2002 at 13:01:23:
Hi Dons, At piston TDC on the compression stroke, the mag needs to be fitted to the engine such that the mag gear tooth marked "x" is visible through the inspection opening (the opening is adjacent to the mag and has a plug in it...remove the plug to observe the mag gear teeth). I have the Wisconsin AENL manual that shows the procedure, along with flywheel TDC markings. I would be glad to scan the two applicable pages and email them to you if you wish. They would be in pdf format so you would need the Adobe reader to view/print. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|