Tractor Talk Discussion Board |
Today's Article Spotlight - be careful !!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on September 29, 2002 at 17:25:34 from (209.47.89.131):
That article featured today from the articles section is a pretty good reference, however the author almost implies that removing all that old brass (needle seat, jets, fuel nozzle) is as easy as pie. Well for those of us who have twisted the brass off and were left with a useless casting, beware that it isn't just that easy. I've found that you have to heat the casting well and evenly (if it's cast iron) with a propane torch before attempting it. Some guys heat up the casting in their gas barbeque. Whatever method you use, must make sure of the pitfalls of trying to remove the brass without knowing of the possible outcome.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|