Tractor Talk Discussion Board |
Re: How do you re-magnetize a magneto?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SEAMO on September 26, 2002 at 19:25:34 from (152.163.188.71):
In Reply to: How do you re-magnetize a magneto? posted by Shawn B on September 26, 2002 at 11:09:19:
I do mag and carb repair. The Bosch is one of the best out there. I doubt if it needs to be recharged. It should be completly taken down to do a perfect recharge. You will need a magnet charger and charging blocks to do the job. Most of the Bosch I get in need points, cond, good brushes in the cap. Sometimes they are carbon tracked real bad on the rotor. The movable breaker plate could be real loose on the pivot point .Therefore you cant keep correct points gap.Start with points and cond and carbon track .I will bet you will get your spark back.Earl
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|