Tractor Talk Discussion Board |
Re: What does it Fit? New Idea Loader.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brokenwrench on September 22, 2002 at 11:51:59 from (200.223.16.74):
In Reply to: What does it Fit? New Idea Loader. posted by TP from Central PA on September 21, 2002 at 17:49:57:
The NI trip bucket loaders were universal fits em all. In other words the loader itself was the same, one would purchase a mounting kit to install it on a SMTA or a JD or Massey or what ever. If you are real lucky, it might have Farmall brackets on it. Otherwise you will have to make up a set to fit your application. As for the hyd. bucket, you will need a 2 spool control valve, 2 hyd. cylinders with enough stroke to allow the bucket to make its full travel and some steel for cylinder mounts and a little bit of engineering to make it work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|