Tractor Talk Discussion Board |
M motors
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Keith on September 18, 2002 at 16:35:20 from (205.186.84.84):
I was looking at the cubic inch displacement of the Farmall M motor and I was amazed to see how big it is. 264 inches out of a four cyclinder. That is 66 inches a hole. That is huge. I did a little calulation to try and figure the bore and stroke. I used a 4 inch bore to start with because for a motor that size in a v-8 configureation a 4 plus bore is about average. To come up with 264 cubic inches a four cyclinder would have to have a four inch bore with approx. a 5 and a quarter inch stroke to equal those cubic inches. I don't know that my bore size is correct but it might be a little to big. I don't know. Does anyone out there know the bore and stroke of the M Farmall?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|