Tractor Talk Discussion Board |
Ford 3400 Radiator Removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tim on September 14, 2002 at 12:54:26 from (205.188.209.109):
Does anyone have any tips / tricks / experience removing the radiator from an industrial Ford 3400 front end loader? I just acquired this tractor earlier this season and this is my first time working on it. The service manual is not much help in this regard (at least the one I have is no help). I have drained the system, removed the hoses and unbolted the radiator from the tractor. My problem is physically removing the unit. The radiator has a fan shround and with the clearances on the tractor, I have not been able to move the unit out. The service manual instructs to remove the shroud if necessary, but the shroud on my tractor is attached to the radiator with 3 screws on each side of the radiator. Again with the clearances, I do not see how to access the screws. The sheet metal on the front of my 3400 is all welded. I will appreciate any suggestions. My goal is to replace the water pump which began blowing water last weekend. Removal of the radiator is only to access the water pump. Tim
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|