Tractor Talk Discussion Board |
Re: help! answer a question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Burrhead on September 13, 2002 at 18:47:19 from (32.101.106.197):
In Reply to: help! answer a question posted by jesee on September 12, 2002 at 19:53:06:
Call over to Ford and ask them the timing degree for the engine. On the injector pump side of the engine look back to the bell housing, there is a small inspection plate about center ways up the housing. Take off the inspection cover, there will be a stamp or chisel mark about center in the front of the hole. Now start rolling the engine in the direction of normal travel until the timing mark on the flywheel lines up with the mark in the inspection hole. It may have several marks on the flywheel but each one is stamped with a number. That number is your time setting. Roll it til the correct numbered mark lines up. Just ahead of the injector pump is another inspection cover for the pump timing. Take the cover off, and adjust the mark on the injector pump drive to match the chisel mark on the housing under the inspection cover. If you have used use the timing mark on the harmonic balancer then you can be 180 degrees out of time but the flywheel is accurate every rotation.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|