Tractor Talk Discussion Board |
Re: Re: Re: Re: Case VAC Generator operation
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on September 10, 2002 at 04:51:53 from (165.170.128.68):
In Reply to: Re: Re: Re: Case VAC Generator operation posted by Ted A. to Bob M on September 09, 2002 at 20:04:22:
Ted - The cutout is simply voltage sensitive relay. It connects the generator to the charging system when the generator voltage is greater than 7 volts, and disconnects when the voltage falls below about 6 volts. It is provided to prevent the battery from discharging thru the generator when the engine is stopped. The cutout relay should "pull in" (close it's contacts) at a motor speed a little over idle. If it does not, try manually pushing the contacts closed with the motor running at about 1/2 throttle. If this causes the ammeter to indicate a charge, it means the cutout is bad. If it does not, the problem is in the generator itself. If you have an ohmmeter, figuring out which generator terminal is which is simple: Disconnect both wires from the generator. Now measure resistance between each terminal and the generator frame. The terminal with little or no resistance will the "A" (or "ARM"). The other one will be "F" (or "FLD") - it should show 2 or 3 ohms of resistance. Hote: These readings assume the generator is healthy. Good luck! ...Bob M
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|