Tractor Talk Discussion Board |
Re: Carb jets
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don Young on September 04, 2002 at 21:31:25 from (66.182.130.205):
In Reply to: Carb jets posted by Leroy on September 02, 2002 at 19:27:55:
Depends on who is doing the numbering, there is no uniform standard. Some are in thousandths of an inch, some are in hundredths of a millimeter, some are in drill bit number size, and some are calibrated for fuel flow in the manufacturers test rig. You can get a pretty good idea if they are by hole size by very carefully comparing them with a set of number 61 to 80 drill bits. Check to see if the number might be the bit size or it's equivalent in thousandths of an inch or hundredths of a millimeter.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|