Tractor Talk Discussion Board |
Re: H tractor block
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on September 03, 2002 at 20:11:44 from (128.242.4.59):
In Reply to: H tractor block posted by lucky on August 26, 2002 at 10:28:07:
Sure sounds like you are in a fix. There is so many options you can do. The right guy might be able to fix it without a hole lot of expense. I know a talented welder/mechanic that has been known to fix stuff like that. But if you aren't attached to the tractor and it is going to run into alot of expense, you would probably be better off getting an entire engine from salvage yard rather than just a block. But there again, you would halve to watch expense becuase if you can buy another running H for less money, that would be a better way to go. And then you would have the H you got now to use for future parts. You will just have to check around and see which is the cheapest way to go.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|