Tractor Talk Discussion Board |
Re: Dodge slant 6 installing instructions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kerry on August 26, 2002 at 17:39:44 from (207.53.229.66):
In Reply to: Dodge slant 6 installing instructions posted by Bill on August 24, 2002 at 08:03:17:
I've seen guys do it with an Oliver. There are some pretty good-sized Olivers from the factory that should take the power, and they have an exposed drive shaft and a clutch arrangement similar to that of a car. Also, some of them could rev pretty high so the RPM incompatibility might not be so bad. I think the best way would be to use a car/truck transmission between the engine and the tractor transmission, that way you could get the rpms down going into the transmission to be about the same as a stock engine. You might need a fairly long tractor and a very short transmission, or at least a short tailpiece on the transmission. I think some of the big modified pullers use an arrangement like that - big engine, automatic transmission like in a dragster, then feed it into the tractor transmission. Sounds like a FUN project!
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|