Tractor Talk Discussion Board |
Re: Re: Re: Re: Driving Bushings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom-TX on August 26, 2002 at 05:02:03 from (12.74.11.144):
In Reply to: Re: Re: Re: Driving Bushings posted by JohnB on August 25, 2002 at 17:36:26:
JohnB. After getting it up on jackstands, I checked the play in the axle and there is very little slack. Also check the spindles and they are tight. I am cleaning and repacking the front wheel bearings and replacing the seals. Got the main steering shaft out and it is ruined. Ordering a new one today from MF dealer for $211 not too bad - could be more. Looks like the single grease fitting for the steering shaft had been missed for about 20 years.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|