Tractor Talk Discussion Board |
Re: Re: Dodge slant 6 installing instructions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DAve on August 25, 2002 at 16:49:55 from (216.42.66.29):
In Reply to: Re: Dodge slant 6 installing instructions posted by G-MAN on August 24, 2002 at 09:38:10:
Something with an open frame and a coupling going into the existing tractor transmission would be about the simpleist. Early Allis or Farmall come to mind.I'm sure there are others set up about the same.Get to some tractor shows with a tape measure in your pocket and do some research. Tractor like that you could use an automatic or manual shift transmission on the back of the slant motor.You will need the extra reduction as the tractor will not have enough low end and will go so fast you will hurt your self.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|