Tractor Talk Discussion Board |
Re: Re: M Farmall Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alton on August 22, 2002 at 15:55:44 from (64.4.103.217):
In Reply to: Re: M Farmall Hydraulics posted by LH on August 22, 2002 at 05:14:29:
Yes 30 weight oil. To remove you have to take out the pipes on the side so to gain clearence. Drive shaft colar slides off pump shaft and drops out bottom. You will need a jack or lift of some sort as very heavy. To test first check fluid level then make sure the drive shaft is connected and turns pump shaft. you can put a 1500 psi. pressure gauge on the outlet pipe. Start and activate control lever you should get about 800 to 1000 psi. over the relief.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|