Tractor Talk Discussion Board |
Re: Re: Re: ford 801 powermaster failure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ErnieD on August 21, 2002 at 17:07:51 from (66.66.131.15):
In Reply to: Re: Re: ford 801 powermaster failure posted by And on August 21, 2002 at 15:36:11:
Condenser is inside the distributer, the black round bakelite plastic thing on the right side of the engine. 5 pencil sized wires coming from the top. pop 2 spring clips from the side top lifts off. pull rotor on the inside straight up. don't lose the spring clip on the shaft. slide black bakelight plastic thingy dome straight up. condenser is round,with a wire from it. Check point gap, I think gap should be 0.022 or the thickness of a thicker match book if you are caught short. The contacts should not be pitted or burned. Replace parts as removed. They are keyed so they can only go together in one way. All are necessary and none left over. Coil is on the side of the engine where center wire of the distributer goes/comes from. Two small wires and one large wire. If you r+r coil there is a difference where the small wires go. Condensers are 1/8 the price of a coil. Not all coils are the same. Next time it quits test for spark. Should be fat and blue.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|