Tractor Talk Discussion Board |
Re: jd 4010 plow pulling ability
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by landlover on August 16, 2002 at 10:31:28 from (63.214.116.191):
In Reply to: jd 4010 plow pulling ability posted by tom poplett on August 15, 2002 at 17:37:23:
If you are running 15.5-38 duals, should we assume you have 5-16's with an on the land hitch? Any fluid in the inner rear tires, or front, rear cast weights? 5-16's pull a lot harder when the tractor's right rear wheel is not in the furrow. Early 4010's came with single 15.5-38's on the rear, usually with semi-mounted 5-14's, the tires lacked bite, so the better match was 18.4-34, the 4010 performance much improved. With some weight to reduce tire slippage, you may pull on land plows in good conditions. Hills and heavy soil would be difficult. Since you are using a forty year old tractor, one assumes minimum acreage, so probably adequate. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|