Tractor Talk Discussion Board |
Re: Re: Re: Novel skidsteer hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RickB. on August 06, 2002 at 14:23:41 from (205.231.149.33):
In Reply to: Re: Re: Novel skidsteer hydraulics posted by Paul on August 06, 2002 at 06:20:43:
There is probably a power beyond plug that is changed when a machine has no aux hydraulics. This would allow the power beyond flow and return oil to comingle and exit the loader valve via the return port. Yes, oil in an open center system will follow the path of least resistance given parallel paths. The key is to not provide parallel paths. When you stroke a valve spool on the loader control, oil that was flowing through the valve and out the power beyond port is diverted to one of the work ports on that valve section. The only oil flowing out of the return port of a power beyond valve is the oil RETURNING from the cylinders. 'Unused' oil that flows through the valve while it is in neutral will exit via the power beyond portand be available for use by the aux valve, if it is in place.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|