Tractor Talk Discussion Board |
Re: Delco alternator question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug in OR on August 04, 2002 at 15:25:33 from (12.225.49.173):
In Reply to: Delco alternator question posted by Ken on August 03, 2002 at 15:20:34:
You can hook the number 2 wire to the + terminal on the battery - or you can hook the number 2 wire to the BAT terminal on the alternator. In this application, it just won't be that critical. If your battery is low, the alternator will try to put 20+ amps to it - hence you will peg the ammeter. A larger ammeter will cure that problem. Better yet, invest in a voltmeter. When you decrease the RPM of the engine, the alternator will stop charging when it's own RPMs drop below approximately 1200. Ideally, the alternator should be putting out 13.8 volts (yes, my radio test equipment can read to the .8 volt) when it is set correctly. Voltages above 14.2 begin to cook the battery.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|