Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Stromberg carburetor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wrenchman on July 28, 2002 at 23:38:29 from (209.214.105.56):
In Reply to: Re: Re: Re: Re: Re: Stromberg carburetor posted by JRV on July 28, 2002 at 13:34:03:
15/16",OK,it should have came off a small 2cyl or 4cyl engine then...it's similar in size to carb on a farmall cub engine...got an old wisconsin 2cyl with a stromberg like that on it...don't know if origonal though...that narrows selection down some...if you can find an old parts manual it just might be possible to figure out what engines it was used on using carb serial # & engine sizes(less than bout 80ci or so)made bfore say 1950...a grey headed parts guy at a napa that has been around a while might be able to look er up for you...will have to look in the books though as it probably won't be on the computer...
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|