Tractor Talk Discussion Board |
Re: Cub 782
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr. Evil on July 22, 2002 at 07:19:51 from (12.4.181.2):
In Reply to: Cub 782 posted by Bob Jack on July 21, 2002 at 16:10:34:
There's a FAQ link on the site Sammy posted the link too. The pockets where those springs set wear and you have to weld/braze up the slots to make the springs tight again. Make sure You don't melt the O-Rings that seal the shaft. Your getting into some mighty complicated assemblies if ou try to remove the shaft & replace it. Internal parts are probably pretty tough to find also because those hydro units are SO durable! If anything fails inside the hydro unit, Really rare occurance by the way, Most people replace the whole hydro unit with a used one.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|