Tractor Talk Discussion Board |
Re: Re: Re: Hydraulic Question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alton on June 26, 2002 at 19:20:37 from (64.4.103.222):
In Reply to: Re: Re: Hydraulic Question. posted by RIckB--- correcting Mike on June 26, 2002 at 14:26:40:
DO NOT take the return line from the first valve and use it as a feed line. If you do the following will result. The first assembly would operate normally, but damage would be caused when a spool in the second valve was shifted. This would cause load pressure to back up against the tank port of the first assembly and against the outlet of the relief. The relief would become useless for pump protection. The back pressure in the tank port of the first assembly could possibly burst the casting, blow the spool seals out and if the areas are different on the ends of the spools it could make them difficult to shift.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|