Tractor Talk Discussion Board |
Re: Re: Hydraulic Top Link
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi. on June 24, 2002 at 14:15:07 from (205.217.66.22):
In Reply to: Re: Hydraulic Top Link posted by rhudson on June 23, 2002 at 20:19:58:
I've made two hydraulic top links out of common cyclinders. The first one was a 1½" cyclinder and it didn't last too long. Soon it had a crack on an end and was leaking, and the end flandges were bent and distorted. Common (cheap) cyclinders just don't have enough "meat" in/on the ends for the severe duty a top link gets. Maybe a better cyclinder could cure some of this, but then it would no longer be a cheap project either. The second one i made out of a 3" cyclinder, and it's holding up a lot better, but i've learned not to use it where it will get abused. I made ends that allow the use of the pins that come with these cyclinders, that adapt to "ball ends". So it wasn't that i had it hooked solid that put all the stress on the cyclinder. Anyway, i think a "real" store bought one would be great to have "if" they didn't cost so much!! And the "home made" one is "ok" if you are carefull with it. Robert
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|