Tractor Talk Discussion Board |
Re: PLEASE HELP ME!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL - consider adding stem wall for added height, less $$ on June 22, 2002 at 06:59:49 from (63.175.91.20):
In Reply to: PLEASE HELP ME! posted by Bowser on June 21, 2002 at 08:32:24:
Hey Bowser - Another consideration to get the hieght is to build a stem wall. While this may seem very apparent I completely overlooked it when building my shop. Had I done so I could have added some additional height all for the cost of minimal block work. My shop height was limited to my budget and as such I only the tallest metal kit I could afford. If I were to do it over I would again build my slab 6" above grade (N. FL), go with a 2-3' stem wall atop the slab, fill the cells with concrete and finish the top. Make sure on slab to include rebar uprights for added strength to the block work. When the block work is nearly finished insert your building anchors. Mine were 1" dia. "Redhead" anchors which held my uprights. The doors can then be ordered to length. FWIW
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|