Tractor Talk Discussion Board |
Re: Re: Re: Super A charging circuit
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 11, 2002 at 08:49:39 from (165.170.128.65):
In Reply to: Re: Re: Super A charging circuit posted by Bob Berg on June 11, 2002 at 04:50:17:
Hey Bob - With your particular setup (3-position switch and voltage regulator), a "low charge" problem cannot be caused by a bad light switch. However here are few possible causes: High resistance in the wiring between the generator ARM and regulator GEN terminals; also between the regulator BAT terminal and the ammeter. Bad connections at the ammeter (happened to me once...) Poor ground at the regulator. Improperly adjusted voltage/current relay in the regulator. Improperly adjusted 3rd brush in the generator. A quick test: Run the engine at full governor and temporarily connect the generator F (or FLD) terminal to a GOOD ground. If the ammeter now shows 10 amps or more, the generator is OK - problem is in the wiring or regulator. If it still only shows a couple amps, the generator is the problem. Hope this helps!! ...Bob M
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|