Tractor Talk Discussion Board |
Torque amplifier
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JHEwen on June 10, 2002 at 17:33:11 from (64.252.76.57):
I have a Farmall 300 with two problems. I have just finished installing a rebuilt short block and have run the engine for a total of 2 hours in 15 to 20 min. intervals. After shutting down from the last short run, I noticed smoke coming from the govenor throtle control where the vent cap is located. The throtle contol was very hot and upon disassembly (after cooling down with a wet rag)I noticed that the end of the aluminum throtle control housing had melted. Apparently I had a fire in this area but don't know why. Would an engine that is too far advanced be the cause? Has anyone experienced this phenomena and what can be done to prevent another occurrence? Does anyone know which direction to turn the distributor to retard. The engine turns over very hard with a new battery, so I think it is advanced too much. Second problem is an transmission oil leak from under the torque amplifier. Are there oil seals in the TA, and does the tractor have to be split to replace? Does a rebuilt TA come with the oil seal installed? Any help or suggestions, greatly appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|