|
Tractor Talk Discussion Board |
Perkins Diesel Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MarkNOhio on May 29, 2002 at 18:02:45 from (207.90.99.140):
Hello Everyone
Hopefully someone can lead me in the correct direction here. I have what I believe to be a late 60's (S/N tag missing but it still has a generator rather than alternator) MF-135 diesel. My problem is that at low speeds, that is less than 1100-1300 RPM it seems to only run on 2 cylinders. Above that speed it purrs like a kitten with plenty of power. I use it mostly with a 6' finish mower to keep our 5+ acres mowed. The governor seems to respond to loads very well and other than this one small problem I'm more than happy with it's performance. I've loostened each injector line at the pump one at a time (yes I was careful, I'm used to working with high pressure systems) and pretty well narrowed it down to the rear cylinder. What do I need? New/rebuilt injectors or an injector pump overhaul? Also, after a period of extended idling (10-15+ minutes) it will very slowly decrease in speed and sometimes just quit. It always starts back up but seems to take a little bit of extra cranking to get it going. Cold, it starts almost instantly. Any help would be appreciated. Oh yeah, what would be a fair price for a set of rebuilt injectors if I have to go that route? Any suggestions as to where to get them?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
