Tractor Talk Discussion Board |
Re: Re: Brush Hog Basics?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray,IN on May 28, 2002 at 19:58:32 from (66.244.72.77):
In Reply to: Re: Brush Hog Basics? posted by Randy Villeneuve on May 28, 2002 at 10:10:14:
Start mowing using a slow gear. When you become familar with the tractor and its behavior you may wish to increase ground speed, but remember- the faster your travel the more likely you are to run into trouble before you can react. 1,500 engine RPM is approx. 545 PTO RPM using engine PTO speed selection; about 2/3 throttle if your tach. isn't working. You may back a pull type brush hog up ramps onto concrete block platforms under each wheel to gain access to the blades for removal and sharpening if an access hole is not available in the deck to remove the bolts. I sharpen my blades with my angle grinder to about 30-35 degrees, it's quick and simple. measure the blade width after sharpening to get within reasonably equal weight for both to minimize vibration and stress on the gearbox. I wouldn't attempt to cut brush without a slip clutch on the PTO shaft to avoid damaging the tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|