Tractor Talk Discussion Board |
Partial gasket set
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan in Ore on May 27, 2002 at 05:42:13 from (198.81.16.56):
I was very disappointed when I got a gasket set from my local automotive dealer for my F-12. It was a Victor brand set, which I have used many times over the years for automotive work. The set cost me a lot of money (more than I would like to admit to). The problem that I have with it is that it was supposed to be a complete set and was only a valve grind set with a pan set thrown in. I really thought that Victor was a lot better than that. I have had to make a lot of gaskets to supplement the set. If it weren't for needing the head gasket and not being able to make that one, I would have tried to take it back. If I would have then I probably would have beencharged a re-stocking fee. Just blowing off a little steam here and maybe keeping someone else from making the same mistake. Dan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|