Tractor Talk Discussion Board |
Re: Farmall H Liftall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Clark on May 25, 2002 at 18:51:19 from (24.154.90.51):
In Reply to: Farmall H Liftall posted by Farmer Steve on May 24, 2002 at 10:09:26:
Seems like the relief setting for H or M is around 1200 psi, using formula r^2*pi where r = radius (1/2 the diameter) of the cylinder and pi = 3.14159 a 2 inch cylinder pushes 3769 pounds or a 3 inch cyliinder pushs 5654 pounds. Remember that generally a loader bucket moves 2 to 4 inchs for each inch the cylinder moves you have to apply that ratio to the cylinder force (divide). It's kind of basic geometry to figure out from here. Remeber that you have two cylinders (unless its one of those Ford one armed bandit loaders) and there has to be enough weight to keep the back of the tractor stable. Also the pump may not be producing 100% of spec. You probably didn't want a disertation, but you get the general idea.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|