|
Tractor Talk Discussion Board |
A BIG Mistake Made Loading a Tractor!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TMAC on May 13, 2002 at 07:16:12 from (207.144.168.5):
Many of you may have done this or know someone who has but if not please read and don't make my mistakes. I was buying a John Deere 60 and I took my trailer over to the owner's house for loading it up. All did not go well. Since the JD60 wheel spacing was wide enough to scrape the inside of the trailer wheels, I suggested we back the tractor on and allow the tires to rub as it passes the last wheel backing on the trailer. My first mistake was to park on a hill with my Silverado and trailer facing downhill. I thought this would reduce the angle of the ramps. I asked the previous owner to drive the tractor and I would direct his movements. As the rear wheels of the tractor got on the trailer, the ramps rotated and the ramp stands came out, the front of the trailer AND REAR OF MY TRUCK came up off the ground. Now there were no brakes and my truck, trailer, tractor, and driver were rolling down hill. The driver could not do anything but ride it out. I could do nothing but watch as my truck smashed into the driveway fence on the back driver’s side at the bottom of the hill. We were a little rattled after that so we decided to load on level ground. We unhooked the trailer, got my truck away from the fence, and hooked back up. Made the attempt one more time and the trailer came up off the hitch and rammed into the tailgate of my truck. In my mental condition I did not latch down the hitch. This damage was worse than the other. Needless to say we stopped trying to load the tractor that day. The next day a friend with a bigger truck and a tilt-back trailer helped without incedent. We were lucky, it could have been worse.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
