Tractor Talk Discussion Board |
Calling all small square baler experts!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DJL on June 16, 2007 at 23:20:59 from (65.161.103.129):
Recently bought a JD 336 small square baler. It had a small amount of sisal twine in it when I picked it up. The guy I bought it from said he ran both 7000 and 9000 twine in it. I bought 4 spools of 9000 plastic twine. Bailed 60 bales with it today and of that 60 had to rebale about 25 or 30 of them. I"m planning on honing up the knives on the knotters, but the question is this, do the knotters have to be reset or re-adjusted to run plastic twine when used to running sisal? The plastic twine is more desirable in my area so I"d like to run it, but had a John Deere guy tell me that you had to retro fit the knotters with different billhooks etc to get it to tie with plastic?? Any advice? Thanks DJL
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|