Tractor Talk Discussion Board |
Re: Any tricks to bead breaking...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Grove r on May 07, 2002 at 18:26:04 from (161.184.18.170):
In Reply to: Any tricks to bead breaking... posted by Dan on May 07, 2002 at 12:38:19:
HI, Dan, something I have used for years, doesn't always work, but works most times; a two inch long piece of two by three eights angle iron, placed on the tire, "v" upside down, one edge next to the rim, drive the iron down along the rim with an eight pound sledge, hit two or three times , then move over a couple inches, do this back and forth on about a foot or so of tire, and usualy this will break it loose. Takes a little practice to keep the iron from flying away, so be careful! And remember, if you want more hitting force out of your long handled sledge hammer, cut six to eight inches off the handle, believe me this works, I stand about six foot and the regular handles are too long for me, I have swedged out many master pins on track equipment, including D8's, and I can hit a lot harder with the shorter handle! have a gooder, R.E.L.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|