Tractor Talk Discussion Board |
Re: Re: Any tricks to bead breaking...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Esev on May 07, 2002 at 18:02:25 from (209.91.3.74):
In Reply to: Re: Any tricks to bead breaking... posted by Chances R on May 07, 2002 at 17:29:34:
I'm with most of these guys too. Big hammer, Tractor bucket, drive onto it with a truck, or tractor. I've done them all, and they work. And if none of those work, and you don't need to save the tire take a sawsall to it (if none of your first tries work, it must be junk anyway, right?). Cut it 90 degrees to the tread all the way across, and down to the beads. Then take a good sharp cold chisel to finish off the beads.Guarunteed to come off now. You might have to touch up the rim with a grinder where you got it with the chisel if your not careful. But that's no worse than those dents you put in it when you missed with the hammer !
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|