Tractor Talk Discussion Board |
Re: Re: Honda atv
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jaarno from alberta on April 29, 2002 at 21:57:40 from (161.184.28.216):
In Reply to: Re: Honda atv posted by Roy on April 28, 2002 at 23:55:13:
To set your timing you must have the piston at top dead center. You can do this by removing the plugs with a slotted screwdriver on the flywheel cover. turn the crank using a socket and ratchetin the big hole and watch for a T mark in the little hole, once you have the piston in the T.D.C position you must put the cam with the lobes down. Then look on the cam sprocket for a . or two - across from eachother, If its a . put it facing straight up. If its the two - then put them parellel to each other with the engine fins. Then put in the sprocket bolts. Be sure to turn engine by hand first when done. Hope this helps, Jaarno
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|