Tractor Talk Discussion Board |
Re: Re: Re: What size plow should I get?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on April 21, 2002 at 17:52:30 from (67.251.143.31):
In Reply to: Re: Re: What size plow should I get? posted by paul on April 19, 2002 at 10:17:01:
Over the last thirty years, I've had AC, Melroe, with AC and Star bottoms, IH 720 (6-18) and White 4-18 and 5-18. White (Oliver) turns the best furrow. IH is very popular, but leaves a rougher field because the front bottom can be held up by a few cornstalks, rather than get down in the furrow where it belongs. It is due to the reset mechanism that slides over shallow rock (although it can trip fully on large rocks). White plows stay down where they belong, until they need to trip. Also, the cast parts on the 720 break due to metal fatigue from hammering on rocks over the years; the White plows stand up better. Had the 720 since 1980, the Whites for the last half dozen years.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|