Tractor Talk Discussion Board |
Re: Re: Re: Re: Brush hog without clutch or shear bolt
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DonP on April 21, 2002 at 04:56:21 from (12.3.156.135):
In Reply to: Re: Re: Re: Brush hog without clutch or shear bolt posted by JD70Jim on April 20, 2002 at 09:55:35:
Not "Over-Riding", and not "Clutch". -What I got was labeled "Over-run coupler". -What it does? In simplest definition, it keeps that heavy blade from being what determines your engine speed. Easiest way to visualize how that matters, is, with it installed, engage your bushhog, wind up the engine. then throttle down to an idle. That "clattering" noise you will hear is caused by the blade spinning faster than the PTO. Without the ORC in place, the blade is "pushing" the engine, causing at least un-expected behavior of the tractor, at worst, twisting the PTO inside, and damaging clutches and other internal parts. (But, you probably knew that.) I just wanted to tell you what ORC was defined as by the maker of my unit.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|