Tractor Talk Discussion Board |
Re: Re: Lugging a Gasoline engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G Taylor on April 15, 2002 at 02:21:07 from (64.10.143.213):
In Reply to: Re: Lugging a Gasoline engine posted by Bill from up north on April 14, 2002 at 20:51:51:
Not to pick a fight or anything, but piston speed in feet per second inside a two cylinder can be faster than a short stroke engine turning higher rpms. The two cylinder engines were not to be lugged or loaded past 80% rated and run at rated rpm under load. For power & economy. Lots have been run lugged to the limit, then the owner wonders why wear rates are higher. Flywheel spline loading increases when lugged & contributes to loose flywheels. I've seen owners at shows who won't ever rev them up to rated rpm because they think they are saving the engine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|