|
Tractor Talk Discussion Board |
Bouncy Wouncy
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TNR on April 06, 2002 at 06:24:45 from (206.74.34.197):
Just traded my 7000 pds trailer for a 10000 GVW.Built pretty much the same with the exception of heavier steel,16 inch tire vs the 15s I had and a Bulldog coupler vs the regular type and other small differences.Problem is that when pulling my new trailer my truck bounces,not so bad that I could lose control but enough to shake my coffee out of my cup.Whats causing this you think and how can I correct it.I havent tried it loaded yet to see if it will do it or not.Oh,it does fine until I get up to about 50 then it starts.Any ideas appreciated!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
