Tractor Talk Discussion Board |
Can someone explain..........
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Oakes on April 04, 2002 at 17:19:38 from (12.89.8.145):
I just bought my first equipment trailer so I can haul my stuff. I have been asking anyone I can about brake controllers for electric brakes. Nobody I have talked with seems to understand how the new electronic units work. In the early '70s, last time I did any trailering, the controller was tapped into the hydraulic brake lines on the truck. This pressure, when pressing on the brake pedal, would move the controller arm across a reostat to modulate the voltage going to the trailer brakes, in proportion to the pressure on the trunk brakes. Can any of you technical types help me understand the new units? How do they know how hard I am trying to stop? Also, any advice on a specific make and model you know to be excellent quality? Thank you!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|