Tractor Talk Discussion Board |
1977 mustang cobra
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jonathan on April 01, 2002 at 16:10:19 from (209.91.3.24):
I just bought last fall a 1977 mustang cobra II (yea I know its off subject) and I'm in the process of restoring it. But, I have found that finding replacement parts for II's are very hard to find because all of the big mustang warehouses don't carry a single thing for the II's. The car body is in excellent shape with almost no rust and a gem to restore being all original, but unfortunatly the interior has been trashed. (seats are ripped,dash has been broken,carpeting is shot,the center consol is missing) I was hoping that maybe some of you are car buffs as well, like I am and might know of where I can get hold of a replacement interior for this car. thanks alot in advance, jonathan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|