Tractor Talk Discussion Board |
Re: Re: Re: Propane Conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Reality Check on March 21, 2002 at 18:42:08 from (130.74.184.124):
In Reply to: Re: Re: Propane Conversion posted by Daniel T. Maxey on March 21, 2002 at 17:22:26:
It seems you have a valid reason. It would require several hours of use to pay for the time and inconvienance of converting. What would you estimate your yearly use to be? The tanks on the professional conversions I mentioned earlier sat where the original fuel tanks were. The hoods had to be modified. I do not think this would be practical for the 8N. You could mount a small tank like used on many small forklifts on a mount in place of a front bumper. This would give you the most visibility. Your best advice might come from a forklift service technician since many still operate on LP. I have seen some units 30 or more years old that have been refitted to use LP for inside use. This is making more sense all the time. I would not make any changes that could not be undone. You may be able to buy used equipment off a junk forklift for most of the conversion. Best of Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|