Tractor Talk Discussion Board |
47 Farmall Light Switch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Buck on March 15, 2002 at 12:56:41 from (208.187.59.107):
My farmall is know runing and I am using the original 6 VDC Pos. ground system. I have turned my attention to the lighting system. I have the original (Or what I think is the original) 4 position rotory light swithch with fuse holder built onto the back of the switch. I figured out the front and back light wiring configeration but what about that coil thing on the side? There is a coil rapped around a piece of cardbard attached between the main switch housing and a curculer part of the housing with a place to attach a wire. Question: 1. What is the side coil for? 2. Do I need the coil system to run the tractor correctly. 3. If I do need the coil system, what wire gets hooked into the imput? I have not found a detailed wiring digram of the light swith and would like any assistance in getting on. Thanks Buck
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|