Tractor Talk Discussion Board |
Re: Ford/ County754 stuck clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike (WA) on March 14, 2002 at 08:41:00 from (67.226.44.164):
In Reply to: Ford/ County754 stuck clutch posted by John on March 13, 2002 at 07:28:40:
Here in the humid northwest, its not an uncommon problem. If the usual rocking, etc., won't work, try starting it in reverse- that always worked on an IH 674 I had. If all else fails, tie the clutch pedal down and remove the starter, then feel around behind the flywheel and pressure plate to see how much clearance you have to get a tool in there. Make a tool by heating the blade of an old butcher knife the appropriate distance from the end and bending a 90 degree angle on the blade. Put it through the starter hole, and work the blade between the clutch disc and flywheel, in one of the gaps in the pressure plate. Move the flywheel to the next pressure plate gap with a crowbar, and repeat. Works every time.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|