Tractor Talk Discussion Board |
Re: Re: Front Loader Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G. L. Perry on March 02, 2002 at 12:16:56 from (216.117.95.62):
In Reply to: Re: Front Loader Help posted by Don on March 02, 2002 at 10:34:18:
Go to www.cadplans.com and they offer plans for loaders you build from scratch or a company can cut some of metal parts for you and sell you parts needed to build. You handy? and have welder/torch and such? No hydraulics on tractor now? 3pt? You can run it off the PTO with a pump that slips on it, yet uses it up for other things tho. some go off front of engine, don't know what's involved there. I would think Kelley or others must have one for your tractor, just big bucks. Have you asked a Ford dealer? Most of old units are the Pipe kind and not as nice as later type, and lot's of times are "trip" buckets, too narrow too. Power steering is much nicer, get a load in bucket and it gets much harder to steer. Wide front is best too, you probly have that now.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|