Tractor Talk Discussion Board |
Re: Can a 3-pt drawbar pull anything?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dell (WA) on February 28, 2002 at 08:09:56 from (205.188.193.159):
In Reply to: Can a 3-pt drawbar pull anything? posted by Newbie on February 28, 2002 at 05:01:16:
Newbie........if'n yer talkin 'bout that 11 hole drawbar, unless ya put a drawbar lock on it to keep it from rotating 'round the end pins, ya gonnna haff problems pullin a trailer ball hitch gettup. The reason 11 holes is to ballance the old pull type plow draft, so yer nott havin' to constantly steer goin down the furrow. Even 3-point mounted plows can have balanced draft problems. But you knew that. Remember to keep a good trailer tongue load onnna yer drawbar 'cuz most 3-point lifts have no down pressure and yer trailer could lift yer lift if'n unbalanced..........Dell
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|