Tractor Talk Discussion Board |
Re: Manifold Hole
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick L on February 19, 2002 at 11:36:05 from (204.246.233.112):
In Reply to: Manifold Hole posted by Jim on February 18, 2002 at 14:17:17:
Ok your goin ta git the doughters on this, but I watched the demos at two different engine shows this past summer. I bought the cast iron rod and the Peterson no.2 High Heat flux that he was selling. He was also selling a special torch set which I didn't buy. I just repaired a manifold with this torch and old cast iron piston rings. It work the same as brazing. The manifold I just repaired had a hole about 3/4" wide and 1 1/2" long. I ground to clean metal about a 1/4" away from the hole, heated the complete manifold and heated the edge of the hole until it started to flow, heated the cast ring and diped it in the flux, then let the ring flow over the edge of the hole. I walked the cast ring around the hole, useing plenty of flux. It worked great.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|