Tractor Talk Discussion Board |
Re: Gaskets, Cutting your own
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CJ on February 10, 2002 at 21:46:33 from (128.113.192.138):
In Reply to: Gaskets, Cutting your own posted by Vince on February 10, 2002 at 20:07:10:
I done this many times as well. I have also learned a few other tricks over the years. One thing that helps for the bolt holes is a set of punches - which I got through manhatten supply. Another thing that works well for cutting the bolt holes is a tapered line-up punch driven through the hole lightly with a hammer. This seems to cut the gasket well and form a nice hole. Lastly, for smaller more precision gaskets I have coated the surface with grease or gear oil, and then basically used it as a stamp to make a nice dark inprint on the material. This way you have a nice outline to cut out with a razor knife. I have made many gaskets leak and haven't had one leak yet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|