Posted by GlenIdaho on December 16, 2023 at 18:12:55 from (172.56.201.210):
One more time!
Greetings to all! Hope you've been having happy holidays! You may recall that a while back I posted about my MS TSX 706 on my 57 850 and questions about the seats etc. I have been working on this carb off and on since. I have been able to adjust the carb so that it runs fairly smoothly, smokes black smoke only upon acceleration then only light smoke, not much, but you know its there. The tractor runs fairly well, but when I pull the plugs they are sooted up pretty bad. Not oily, but black soot. As a reminder the engine has been rebuilt to include a valve job. Carb rebuilt too. I installed a Petronix ignition kit and Flame Thrower coil. Obtained immediate start up, which in reality was only marginally better that when stock. My rational was that a hotter spark would burn the fuel more completely. It may have, but the plugs were still black with soot. Yes, they were cleaned before the electronic ignition was installed. In searching for answers I found what is called Colortune which enables you to see the combustion as it happens. It is a spark plug device with a glass insert through the plug. Following the directions, when a carb is adjusted correctly you should see blue flame. I see blue flame while at idle. However upon acceleration the flame turns yellow which indicates too much fuel. Yellow flame is expected initially but is supposed to change to blue if the carb is adjusted properly. I was not able to achieve a blue flame at higher rpms. I checked all the recommended areas suggested by the manufacturer, no vacuum leaks. I contacted the Colortune company and they could only suggest the main jet was too large. I am going to take the carb apart again and examine each part. One thing have noticed is that the float spring from the rebuilt kit is different than the original. The original used a small coil spring, the rebuilt kit uses the type that clips on to the needle. I am considering putting all the old parts back in to see how that works. I am running out of ideas and am now thinking the carb is just no good and need to buy a new one. One thing I have considered is the precision by which the MS carb operates. I do not think it is that precise and perhaps I am expecting too much from it and that it will never produce a yellow flame at high rpm. I am looking for any suggestions. I have looked at the Zenith carbs and understand many are very happy with them, but rebuilt kits are also non-existent. Any feedback on the Zenith carb would be appreciated. I want to thank again all those who tried to help previously and perhaps have thought of something new. I apologize for the long post. Hope you have a wonderful week. Thank you in advance.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
