Posted by Fixingfarmer on December 07, 2023 at 02:56:06 from (166.181.84.90):
In Reply to: Chisel plow point ? posted by smalltimer on December 06, 2023 at 00:38:26:
So a spring loaded shank trips when you feel the rocks with a rigid. The real question is how often do you feel that rumble? 5 times a field? Twice per year? How fast traveling? With the size of points they put on modern ones with wings who cares about a little twist that wont bother enough to scare me if its what I wanted to try. People like to blame a lot of things on broken shanks but it comes down to hitting stuff at a high rate of speed. I know its not as deep but My boss when I pulled the anhydrous bar at the coop was pretty sure my rigid shanks would be destroyed by me putting grade 8 bolts in the knives...I didnt say I was replacing the big shank bolts up top just the knives. Didnt loose a shank over 7500 acres at 7 mph. 3 shank bolts sheered always use the right shank bolt you want it to sheer
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.