IaLeo -- Thank you. I don't get to do it often, but it is a lot of fun to take grandpa's old WD and get into the dirt.
flying belgian -- Thanks!
super99 -- Yeah I don't quite "get" youtube shorts...
Mark-Mi -- Sure does! Gave her quite a workout.
Traditional Farmer -- Yeah only a few people playing around or doing gardens use plows anymore. Other than an occasional pass with a chisel plow around the field edge or drive lanes to loosen up roots and compaction.
tomstractorsandtoys -- Dang, very nice deal! This one was grandpas, it came into my possession back in the early 90s. Been a good tractor.
DoubleR -- Oh yeah, I can plow the field in bean years with bean trash on top, but no way could I try and plow under all that corn trash. Whew, that'd have been fun to try!
jddrawbar -- True story!
Northvale PA -- Isn't that the luck. Looking forward to only needing to disc come spring here.
GermantownGreen -- Thanks, glad you enjoyed! Rolled over just like I was hoping and shined the plow up nicer than ever before, I was really happy!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
